Vending coil pitch: how much stock will a wider spiral hold?
Vending coil pitch is the distance from one turn of a spiral to the next, measured along the row. Think of the distance between the centres of two neighbouring wires at the bottom of a tray. A vendor choosing a spiral for a new snack needs that measurement in millimetres. The number of products the row holds is a separate figure.

Read the two numbers on the parts list
A supplier might describe a spiral as a ten-count coil. That tells you the intended number of products in the row. It tells you very little about the length of the tray. Two rows that each hold ten items could be different depths. Before ordering, ask which tray the part fits and which units the supplier uses for the spacing.
The figures in one SandenVendo manual, section 4.1.2, show how this works. It lists two spirals with the same 472 mm length and 64.5 mm diameter. The 25 mm step has a listed capacity of 17 products. The 45 mm step has space for ten. These are examples for the equipment covered by that manual. Use the parts list for the machine on your own site.
What does a wider vending coil pitch cost in capacity?
Imagine a workplace changing from a slim bar to a thicker packet. If the two spirals above were both compatible with its tray, switching to the wider one would remove seven selling positions. Across three identical rows, that would take the total from 51 packs to 30. That difference matters even when both products sell at exactly the same rate.
For example, suppose staff buy twelve packs a day across those three rows. Thirty packs cover two full days and leave six for the third day. Fifty-one packs cover four full days and leave three. This is a planning example. Use actual sales by selection when deciding whether the new pack needs a second facing or an earlier refill.
Compare the sample with the drawing
Ask the supplier for a drawing that labels the step, the diameter and the overall length. Mark the dimension you are discussing before exchanging measurements. Measuring the outside width of a spiral answers the diameter question. Measuring the empty gap between two wires gives a smaller figure than measuring between their centres. Keep the original units alongside every number.
Take several unopened samples from the proposed case. Stand each one in the intended selling position and compare their thickness at the fullest point. A wrapper seam may stick out further than the bar inside it. Give the operator the range you found. Avoid treating a sample squeezed flat on a desk as a reliable guide to how a row will load.
Decide whether to change the row
Ask the operator to show you the proposed product in a compatible row before committing to a case order. Record how many unopened packs fit comfortably, whether a pack drops cleanly and whether its wrapper stays intact. Keep the part reference and a photograph of the pack with your refill notes. If the brand changes its packaging, repeat the check before accepting the new case.
When comparing quotes, put the proposed count beside the actual refill visit day. A change that looks small on paper can leave the Friday evening shift with an empty row until Monday. Ask whether a different pack size would keep the product available across that gap.
For a simpler introduction, see how a vending spiral moves a product. If you are comparing configurations, ask Vending-Machines.ie about your proposed pack size, machine model and refill interval.


